Before assemble of the scanner and stand make sure that all contents are present.
The Scanner stand contains:

  • Two Caster Frame  <<pictures of each component>
  • Two Side Stay
  • One Center Bar
  • Twelve Regular Screws
  • Four Coin Screws
  • Assemble tool
  • Document basket
  • Support Wires
     

Assemble the stand before mounting the scanner unit.

Activate the video by moving the cursor over the video clip to the right.

  
1. Assemble the caster frame and the side stay using the four screws provided. The caster frames and side stay are identical so there is not left and right side stay.

 

2. Attached the center bar to the side bar stays using the four screws provided.

 

3. Hold the scanner unit by the side covers on both sides as you adjust its position until the rubber feet on the underside of the scanner unit are aligned with the notches in the fixing plate of the scanner stand. Place the scanner unit on the stand and secure it in place using the four coin screws provided.
Secure the side stays in place by tightening up the four center bar fixing screws.

 

4. Attach the basket to the stand. Positions frames1 and 2 so that they rest on screws A and are hooked onto screws B in order to attach the basket.

 

 

5. Attach frame 3 to screws B below screws A and stretch out the basket cloth

 

6. Attaching the document support wires for Thin documents.
  1. Insert one end of the document support wire provided into the slot at the rear of the scanner. There is a second, hidden slot underneath the first slot. Make sure that the tip of the document support wires is also inserted firmly into the second slot.
  2. Squeeze the document support wire and insert the other end. In the same way as step a above. Make sure that the tip of the document support wire is also inserted firmly into the second slot.
  3. Insert the middle section of the document support wire into the elongated slot in the scanner unit.
  4. Attached the other document support wires in the same manner.

 


(a)


(b)


(c)
7. Remove the cushion material that is included below the document hold-down unit before using the scanner.