Loading a Document

Insert the document with the surface to be scanned face downward into the scanner until the top edge of the document contacts the feed rollers.

Activate the video by moving the cursor over the video clip to the right.

Loading a Thin document

1. Ensure that the thin document support wires is installed. See Assembly.
2. Move the document guides to the left and right until they are adjusted to the document width
3. Place the document between the document guides and the insert the document into the gap between the top cover and the document scanning table. Make sure that it is straight.
4. When the preset delay time specified in the driver software has elapsed the rollers start turning to automatically feed the document to the position to start scanning. The document is now loaded.
5. After the document has been loaded move the document guide s back to the position where the "document edge" dotted line can be seen.

Loading a thick document

1. Ensure that the thick document support unit is installed. See Assembly.
2. Press the [ITA] button on the operator panel to change to ITA mode (the ITA LED lights up)
3. When a document is placed on the paper sensor as shown below and inserted into the recess the top cover start to rise automatically after approximately 2 seconds.
   If it does not rise automatically press the [FORWARD] button.
   
4. When the top cover has risen to the upper limit position, insert the document further so that it can be seen from the rear of the scanner.
   Lowering will start after approximately 5 seconds after the document is detected by the front and rear paper sensors.
   
5. When the document is inserted into position the top cover automatically descends to detect the thickness. If it does not automatically descend press the [REVERSE] button.
   

.

Reloading a Document

If you want to reload the document, press the [REVERSE] key to eject the document in the front. Reload the ejected document.
When the document has been loaded, the [PAPER] LED lights up.